STANDARD RIGGING FEATURES INCLUDE:

TELEFLEX QC HELM BEZEL AND STEERING WHEEL
MEP SOFT CONSOLE WITH TACH, OIL, H2O, VOLT, HOUR, FUEL, HORN, KEY
5 SWITCH ACCESSORY PANEL WITH EXTRA WIRING FOR FUTURE OPTIONS
50 GALLON CUSTOM ALUMINUM NMMA CERTIFIED FUEL TANK
CUSTOM FUEL SPILL VENT FOR DRAINAGE AWAY FROM PAINT
550 GPH BILGE PUMP WITH AUTOMATIC FLOAT (FUSED HOT)
BILGE BLOWER
NAVIGATION & ANCHOR LIGHTS WITH APPROPRIATE POLES
3/8" WELD ON BOW EYE AND TWO SINGLE HOLE TRANSOM TIE-DOWNS
TWO STAINLESS STEEL SEAT PIN MOUNTS
TROLL MOTOR REINFORCEMENT PLATE PORT SIDE
DRIVER CONSOLE WINDSHIELD
SILENT SYSTEMS EXHAUST MUFFLERS
BATTERY BOX (NO BATTERY)
NO SEAT OR BENCH TOPS
LARGE PORT SIDE GLOVE BOX WITH DOOR



STANDARD HULL FEATURES INCLUDE:
22' L.O.A. 86" BEAM, 72" 12 DEGREE BOTTOM
MULTI-STRAKES, DELTA PAD, REVERSE CHIN, HYDRO-DYNAMIC BOTTOM (MSDPRC)
FORWARD FRONT 5 WINDOW SPLIT WALK THRU SYSTEM
PRE-FLEXED EXTRUDED GUNNELSIDES, LONGITUDNAL STRINGER STRUCTURE
** INDMAR PORT FUEL INJECTED 5.7 RAW WATER ENGINE **
** AMERICAN TURINE SD-309 JET PUMP WITH "A" IMPELLER **
20'4" LONG x 72" WIDE, 0.250" THICK, 12 DEGREE REAR SECTION (5052)
0.190" 5052 BOW SECTIONS, 0.125" REINFORCED 5052 ONE PART SIDE MATERIALS
FIVE LONGITUDINAL STRINGERS, 1/4" CENTER, INVERTED COMPOUND "S" INNER
RAILS & 1/4" OUTTER SYSTEM
COCKPIT FLOOR X-BRACE =10" MAX.DISTANCE BETWEEN BRACES
32" HIGH, 0.125" THICK PRE-FLEXED FORMED GUNNEL SIDES
20" FULL WIDTH INTEGRATED TO SIDE SWIM DECK (22" L.O.A.)
4 @ 0.190" THICK LONGITUDINAL LIFTING STRAKES
DROP FRONT CASTING DECK WITH LARGE STORAGE COMPARTMENT
DUAL SPLIT CONSOLE WITH D.O.T. 2 TINTED SAFTY GLASS
FLUSH REAR DECK / MOTOR COVER (NO HUMP) WITH GAS LIFT
SELF BAILING FRONT CASTING DECK
FRONT ANCHOR STORAGE WELL
COMPLETE SPRAY LINER INTERIOR,DECKS & SWIM DECK
SPRAY LINER ON GUNNEL TOP DOWN TO OUTER SOFT BODY LINE
D.O.T. 2 TINTED SAFETY GLASS, NO INTERIOR CARPET
ADDITIONAL X-LARGE TWIN REAR STORAGE COMPARTMENTS
LOCKING LATCHES ON LARGE DOORS
PUMP CLEANOUT ON EXTERIOR OF HULL
FULL LENGTH STRUCTURAL SIDE TRAY BRACE
TWO CUP HOLDERS
FRONT & REAR DECK PIN MOUNTS (TWO)
CHROME VENTURI COVERS
NO SEATS

 

All of our boats are manufactured in the USA from tempered Magnesium/Aircraft Aluminum.  All of our watercraft are welded, not riveted to create a longer life and free from leaks. Whether its a 20ft river boat or a 52ft commercial craft, we can exceed your expectations. We custom install all of our interior, from vinyl to carpet or Military grade spray lining we have any option available to you. Check out our full line of custom boats and contact us for a free quote. We also manufacture a rescue boat line that is widely used across the USA.

Rapture VI

STANDARD RIGGING FEATURES INCLUDE:

TELEFLEX QC HELM BEZEL AND STEERING WHEEL
MEP SOFT CONSOLE WITH TACH, OIL, H2O, VOLT, HOUR, FUEL, HORN, KEY
5 SWITCH ACCESSORY PANEL WITH EXTRA WIRING FOR FUTURE OPTIONS
50 GALLON CUSTOM ALUMINUM NMMA CERTIFIED FUEL TANK
CUSTOM FUEL SPILL VENT FOR DRAINAGE AWAY FROM PAINT
550 GPH BILGE PUMP WITH AUTOMATIC FLOAT (FUSED HOT)
BILGE BLOWER
NAVIGATION & ANCHOR LIGHTS WITH APPROPRIATE POLES
3/8" WELD ON BOW EYE AND TWO SINGLE HOLE TRANSOM TIE-DOWNS
TWO STAINLESS STEEL SEAT PIN MOUNTS
TROLL MOTOR REINFORCEMENT PLATE PORT SIDE
DRIVER CONSOLE WINDSHIELD
SILENT SYSTEMS EXHAUST MUFFLERS
BATTERY BOX (NO BATTERY)
NO SEAT OR BENCH TOPS
LARGE PORT SIDE GLOVE BOX WITH DOOR



STANDARD HULL FEATURES INCLUDE:
22' L.O.A. 86" BEAM, 72" 12 DEGREE BOTTOM
MULTI-STRAKES, DELTA PAD, REVERSE CHIN, HYDRO-DYNAMIC BOTTOM (MSDPRC)
FORWARD FRONT 5 WINDOW SPLIT WALK THRU SYSTEM
PRE-FLEXED EXTRUDED GUNNELSIDES, LONGITUDNAL STRINGER STRUCTURE
** INDMAR PORT FUEL INJECTED 5.7 RAW WATER ENGINE **
** AMERICAN TURINE SD-309 JET PUMP WITH "A" IMPELLER **
20'4" LONG x 72" WIDE, 0.250" THICK, 12 DEGREE REAR SECTION (5052)
0.190" 5052 BOW SECTIONS, 0.125" REINFORCED 5052 ONE PART SIDE MATERIALS
FIVE LONGITUDINAL STRINGERS, 1/4" CENTER, INVERTED COMPOUND "S" INNER
RAILS & 1/4" OUTTER SYSTEM
COCKPIT FLOOR X-BRACE =10" MAX.DISTANCE BETWEEN BRACES
32" HIGH, 0.125" THICK PRE-FLEXED FORMED GUNNEL SIDES
20" FULL WIDTH INTEGRATED TO SIDE SWIM DECK (22" L.O.A.)
4 @ 0.190" THICK LONGITUDINAL LIFTING STRAKES
DROP FRONT CASTING DECK WITH LARGE STORAGE COMPARTMENT
DUAL SPLIT CONSOLE WITH D.O.T. 2 TINTED SAFTY GLASS
FLUSH REAR DECK / MOTOR COVER (NO HUMP) WITH GAS LIFT
SELF BAILING FRONT CASTING DECK
FRONT ANCHOR STORAGE WELL
COMPLETE SPRAY LINER INTERIOR,DECKS & SWIM DECK
SPRAY LINER ON GUNNEL TOP DOWN TO OUTER SOFT BODY LINE
D.O.T. 2 TINTED SAFETY GLASS, NO INTERIOR CARPET
ADDITIONAL X-LARGE TWIN REAR STORAGE COMPARTMENTS
LOCKING LATCHES ON LARGE DOORS
PUMP CLEANOUT ON EXTERIOR OF HULL
FULL LENGTH STRUCTURAL SIDE TRAY BRACE
TWO CUP HOLDERS
FRONT & REAR DECK PIN MOUNTS (TWO)
CHROME VENTURI COVERS
NO SEATS

Rapture VII

R & L

Marine